Project Editor [Deprecated]
The project editor allows you to visualize and adjust which data is going to be processed and billed by Prevu3D.
Accessing the project editor
Section titled “Accessing the project editor”Once you have uploaded all of your project data and ready to launch you build, you may access the project editor within the pointcloud View Datasets section and select Create a project.
Editing your project
Section titled “Editing your project”In the project editor, you will be able crop out parts of your point cloud by moving the blue handles around.
The GB consumed from your available Processing is calculated based on the area selected.
Using handles
Section titled “Using handles”You can easily add and remove cropping points to add greater accuracy to your crop. Just click on the + to add a point. Then drag the points to adjust the crop.
Viewing modes
Section titled “Viewing modes”To adjust the minimum and maximum height of the point cloud, you should change the viewing mode from top to any of the side views.
Launching the build
Section titled “Launching the build”Once you have finished cropping your project, an approximate GB calculation of your space is done. You may then launch your build by pressing Confirm.